Hey there, Pumpkin - passion for Moonlight continues!

Croptopia Getaways create and take 2:  "Hey there, pumpkin"

note: click photo to see a larger image

cutting guides for the pieces that need to be cut:

Cutting instructions: 

Cut full sheet of Sweet Leaf cs into:  (four) 4” x 6” mats and (three) 3” x 4” mats.

Cut full sheet of Goldrush cs into two 4 ¾” x 10 ½” pieces.

Use patterned paper for both left and right bases.  On bases, and from top to bottom, with the pieces flush with the inside edge, adhere the following pieces:
1. Adhere the Slate cs 4” x 8 ¾” piece 1 ¼” from the top edge of the base.
2. Directly below, adhere the 1” x 11” black cs strip.
3. Directly below, adhere the 4 ¾” x 10 ½” Goldrush cs strip.

To create the left side:
1. Adhere a 4” x 6” Sweet Leaf mat in the upper right corner of the Slate cs.  This is approx. ¼” down from the upper edge of the Slate and approx. ¼” from the right edge of the base.
2. Directly below the above mat, adhere the 3” x 4” Sweet Leaf cs mat.  This is also approx. ¼” up from the bottom edge of the Goldrush cs.
3. To the left of the above piece, and in line with the bottom of the same piece, adhere a vertical 4” x 6” Sweet Leaf cs mat.
4. In the left corner of the above photo mat, adhere chipboard pumpkins with foam tape.
5. Directly below the black strip, and to the left of the 4” x 6” Sweet Leaf mat, add Black dots.
6. Adhere the black title over the Sweet Leaf base.  Attach title with 3-d foam tape.  This over laps the top right photo as desired.

To create the right side:
1. Center, and align Sweet Leaf cs mats within the Slate and Goldrush pieces.  The two 3” x 4” mats are at the top and horizontal and the two 4”x 6” mats are on the bottom and are vertical.
2. Add a cluster of Black Dots in the lower right corner as desired.
3. Add a horizontal row of three Black dots along the top of the leftward 3” x 4” photo mat.
4. Adhere Slate 3/8” x 2 ¼” strip to the black strip.  This is flush with the left edge of the Sweet Leaf mat and centered within the black.
5. In the upper right corner of the base, adhere two chipboard pennants as desired.